this is on a separate page, so I can build a combo test (FMS) to display on the top page

In <0D5B2E64-803A-48E3-8A4E-9D40F8E5B75F at haskins.yale.edu> Richard Crane <richard.crane at haskins.yale.edu> writes:

Can anyone tell me why the second of these two hosts generates a warning = (and turns bbtest yellow), but the first does not? =20

xx.xx.xx.xx litt.haskins.yale.edu # bbd =20 xx.xx.xx.xx litt # prefer noconn ssh = http://litt/synbak/2011/index.html

"litt.haskins.yale.edu" is different from "litt". Xymon uses the full string that you provide, so with/without a domain is considered two different hosts.

yy.yy.yy.yy tjmac # ssh ldap FMS pptp http://tjmac/fmi-test/phptest.php yy.yy.yy.yy tjmac # prefer noconn fm-5003 fm-16000 fm-16001 = NOPROPRED:fm-5003,fm-5353,fm-2399,fm-16000,fm-16001,fm-16004 = http://tjmac/fmi-test/phptest.php

These are identical. And when you have the same host listed twice, you MUST list all of the network tests on one of the lines.

So your config should be

yy.yy.yy.yy tjmac # ssh ldap FMS pptp
http://tjmac/fmi-test/phptest.php
fm-5003 fm-16000 fm-16001 NOPROPRED:fm-5003,fm-5353,fm-2399,fm-16000,fm-16001,fm-16004

and then later

0.0.0.0 tjmac # noconn

You cannot control what status columns show up on each of the two lines by splitting the test-specifications between the two lines. If you want a status to only appear on one of the entries, then use the "group-only" or "group-except" definitions.

Regards, Henrik