Hello,

I tried to run a .vbs script to monitor some units in IP21.

The script is working, but the results only appeared on Xymon monitoring for 1 server, but not for other servers. I could run the script manually on other servers, and the result would show on the monitoring screen, but some how, the servers just didn't "see" that line in the configuration file (the log file showed that it read the line above it, then skipped the line for the script, and ran the one below it).

The same account was used for all servers with local admin and application admin right.

Any suggestion is greatly appreciate it.

*Best regards,*

*ThanNhi Nguyen*

*IS MES Support* *3737 Buffalo Speedway*

*Houston, TX 77098-3701T: 1-713-525-6740M: 1-713-247-9278*

[image: SOLVAY]

www.solvay.com

--

*This message and any attachments is intended for the named addressee(s) only and may contain information that is privileged and/or confidential. If you receive this message in error, please delete it and immediately notify the sender. Any copying, dissemination or disclosure, either whole or partial, by a person who is not the named addressee is prohibited. We use virus scanning software but disclaim any liability for viruses or other devices which remain in this message or any attachments.*******************************Ce message, ainsi que toute piece jointe, est exclusivement adresse au(x) destinataire(s) nomme(s) et peut contenir des informations confidentielles. Si vous recevez ce message par erreur, merci de le detruire et d'en avertir immediatement l'emetteur. Toute copie, transmission ou divulgation, integrale ou partielle, par une personne qui n'est pas nommee comme destinataire est interdite. Nous utilisons un logiciel anti-virus mais nous denions toute responsabilite au cas ou des virus, ou tout autre procede, seraient contenus dans ce message ou toute piece jointe.*