First make sure the clients are reporting to your server (should have asked you the IP address when you compiled the clients.
As for hobbit-clients you can do the configurations for each server if you wish by using the following:
HOST=host1, host2 DISK 90 95 PROC ccApp.exe 1 MEMPHYS 99 100
HOST=host3 DISK 80 90
DEFAULT UP 1h LOAD 5.0 10.0 DISK %^(/vob|/cdrom).* IGNORE DISK %^/(mnt|tap).* IGNORE DISK * 90 95 MEMPHYS 100 101 MEMSWAP 50 80 MEMACT 90 97
-----Original Message----- From: Christian Rehberger [mailto:c.rehberger at oclcpica.org] Sent: 22 September 2006 12:35 To: hobbit at hswn.dk Subject: [hobbit] How to configure Clients
Hello,
I'm using hobbit since mondy this week and now I run in problems how to configure various checks on various clients.
Ok, I built a hobit server sucsessfully. The network tests works all fine.
But now I have to check disk space and procs on two other machines. I've installed the client on each machine but I cannot configure the warnlevel or paniclevel of these clients or procs at all.
It seems, that only entries in the server located file "hobbit-clients.cfg" takes care?
My problem is, that I have to use different levels on each client machine!
Whats wrong with my configuration?
Thankx
Chris
-- Christian Rehberger System Consultant · OCLC PICA GmbH Grünwalder Weg 28g · 82041 Oberhaching · Germany t +49-(0)89-61308 333 · f +49-(0)89-61308 399 e c.rehberger at oclcpica.org · w http://www.oclcpica.org
To unsubscribe from the hobbit list, send an e-mail to hobbit-unsubscribe at hswn.dk