[hobbit] fix to 4.2.0 uid and gid checking

Thanks Bill! We don't often get complaints accompanied by solutions! Most folks stop at the complaint. Thank you very much for helping to advance Hobbit!

GLH

From: Bill Baker [mailto:bill.baker at mfms.com] 
Sent: Thursday, September 25, 2008 12:12 PM
To: hobbit at hswn.dk
Subject: [hobbit] fix to 4.2.0 uid and gid checking



I attempted to use FILE uid and gid checking in

hobbit-clients.cfg. I ran into the same problem listed below on an e-mail dating back to 2007. There was not a thread that showed a correction to the problem so I search your source code for the problem. I found it in the module client_config.c. In your original 4.2.0 code, the +8 below were +6. From what I can gleam from module client_config.c, the you had planned to use "owner" and "group" until you realized that group was reserved, so you switched to "ownerid" and "groupid". The only problem was that you did not change the parsing position for the input data.

Bill

 

 

                                               uid =

strtol(tok+8, &eptr, 10);

                                                if (*eptr ==

'\0') {

                                                        /* All

numeric */

currule->flags |= FCHK_OWNERID;

currule->rule.fcheck.ownerid = uid;

                                                }

                                                else {

currule->flags |= FCHK_OWNERSTR;

currule->rule.fcheck.ownerstr = strdup(tok+8);

                                                }

                                        }

                                        else if

(strncasecmp(tok, "groupid=", 8) == 0) {

                                                /* Cannot use

"group" because that is reserved */

                                                char *eptr;

                                                int uid;

 

                                                uid =

strtol(tok+8, &eptr, 10);

                                                if (*eptr ==

'\0') {

                                                        /* All

numeric */

currule->flags |= FCHK_GROUPID;

currule->rule.fcheck.groupid = uid;

                                                }

                                                else {

currule->flags |= FCHK_GROUPSTR;

currule->rule.fcheck.groupstr = strdup(tok+8);

                                                }


 


 


 


##########


problem checking directory oid / gid

*	To: hobbit (at) hswn.dk 
*	Subject: problem checking directory oid / gid 
*	From: Joost van den Broek <joost (at) seat-ibiza.nl> 
*	Date: Sun, 18 Feb 2007 21:16:22 +0100 
*	User-agent: Thunderbird 2.0b2 (X11/20070209) 

size=2 width="100%" align=center> 
Hi,

 

I get the following status message:

 

/tmp
File is owned by user root  - should be d=root
File is owned by group root  - should be d=root

 

The config files contain:

 

hobbit-clients.cfg
FILE /tmp yellow type=dir ownerid=root groupid=root mode=1777

 

client-local.cfg
file:/tmp


Removing ownerid and groupid will give back a green status -

what is going wrong?

Thanks,


Joost

 

 

Confidentiality Notice: 
This is a transmission from a Winter Haven Hospital facility.

This message and any attached documents may be confidential and contain information protected by state and federal medical privacy statutes. They are intended only for the use of the addressee. If you are not the intended recipient, any disclosure, copying, or distribution of this information is strictly prohibited. If you received this transmission in error, please accept our apologies and notify the sender.

This Outbound Message has been scanned for Viruses and

objectionable content by McAfee Secure Internet Gateway.