Another update for this topic:
I added 100 file systems to a couple systems to see what would happen with the graphs. The target systems were different from the one that spawned this topic.
When I added 100 file systems to a Linux (RHEL 6.6) system, all file systems were reported/graphed on the disk page. When I added 100 file systems to an AIX (v7.1) system, file systems were truncated; although at a different point. 120 of 132 file systems were represented..
I don't understand why they're so different. Comparing the df portions of the messages from each of the systems do not reveal any obvious differences.
I'd really appreciate some suggestions for debugging. What commands I can run manually that the disk page is running internally. I've looked at the code, but haven't quite figured out what's going on in there; my C skills are rubbish.
Erik D. Schminke | Associate Systems Programmer Hormel Foods Corporation | One Hormel Place | Austin, MN 55912 Phone: (507) 434-6817 edschminke at hormel.com | www.hormelfoods.com