You seem to have $XYMONHOME defined as "." rather than the full path to the directory.
On 13 September 2012 22:52, Kemi Ariyo <kemi.ariyo at issolutions.co.uk> wrote:
Hello,****
I am trying to configure my xymon client 4.3.10 to local mode i.e. allow client to do the proc check locally and I keep getting this error****
bin/xymonclient.sh: ./bin/xymond_client: not found****
Can anybody please assist****
Thank you****
*Kemi Ariyo*
*IS Solutions plc*
*Switchboard: 01932-893333*
*Direct: 01932-893327*
*Fax: 01932-893433*
*Mobile: *
*http://www.issolutions.co.uk*
Disclaimer:
This message is intended for the addressee only. It may contain information of a confidential or legally privileged nature. If you have received this message in error please notify the sender and destroy the message immediately. All attachments have been scanned for viruses. However IS Solutions plc cannot accept liability for any loss or damage you may incur as a result of virus infection.
Xymon mailing list Xymon at xymon.com http://lists.xymon.com/mailman/listinfo/xymon