Ok, so I'm reading the man page for the analysis.cfg file, and in the disk section, it reads:
If the utilization of "filesystem" is reported to exceed "warnlevel" or "paniclevel", the "disk" status will go yellow or red, respectively. "warnlevel" and "paniclevel" are either the percentage used, or the space available as reported by the local "df" command on the host. For the latter type of check, the "warnlevel" must be followed by the letter "U", e.g. "1024U".
I'm fine with all of this except: What will the "U" number represent? Is it megabytes, gigabytes? I'm assuming megabytes, but would like to be sure.
Thanks.
--
Mike Burger
AIX Administrator
<http://freedomhome.fhmc.local/intranet/main.jsp>
Phone (317) 537-3680, Fax (317) 537-4680, Cell (317) 797-2040
E-mail: Mike.Burger at FreedomMortgage.com <mailto:Anthony.House at freedommortgage.com>
"Once word leaks out that a pirate's gone soft, people begin to disobey you and then it's nothing but work, work, work, all the time." --Westley/The Dread Pirate Roberts
CONFIDENTIALITY NOTICE: This e-mail message, including all attachments, is for the sole use of the intended recipient(s) and may contain confidential information. Any unauthorized review, use, disclosure, alteration or distribution is strictly prohibited and may violate state or federal law. If you are not the intended recipient, please contact the sender by reply e-mail, delete this email and destroy all copies of the message.