Hi, any news about the errors below ?

I've got the same errors :-(

Latest error messages: Loading hostnames Cannot load host data Loading saved state Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Too few fields in record - found 6, expected 17 Setting up network listener on 0.0.0.0:1984 Setting up signal handlers Setting up xymond channels Setting up logfiles Setup complete Whoops ! Failed to send message (timeout) -> -> Recipient 'XXX.XXX.XXX.XXX', timeout 15 -> 1st line: 'config hosts.cfg' Cannot load hosts.cfg from xymond, code 7 Failed to load from xymond, reverting to file-load

It will run again one minute later and work normally.

.. me too ?!

cheers, martin

On Wed, 21 Sep 2011, Henrik Størner wrote:

On 20-09-2011 22:40, Tom Diehl wrote:

...

I just upgraded from 4.3.4 to 4.3.5 and I am getting errors that I do not understand. I would appreciate it if someone could tell me what to look at to correct the errors in the following log snippets:

==> xymonlaunch.log <== 2011-09-20 16:06:59 xymonlaunch starting 2011-09-20 16:06:59 Loading tasklist configuration from /usr/lib/xymon/server/etc/tasks.cfg 2011-09-20 16:06:59 Loading hostnames 2011-09-20 16:06:59 Cannot load host data

This one puzzles me a bit. Supposedly it comes from xymond while starting up, but xymond should not have problems loading hosts.cfg.

...

==> xymongen.log <== 2011-09-20 16:07:04 xymond status-board not available, code 0 2011-09-20 16:07:04 Failed to load current Xymon status, aborting page-update

This is not unusual when Xymon starts. It happens because xymongen (the tool that generates the static overview webpages) tries to fetch the current status from xymond before it is ready (e.g. because it is loading the saved state).

It will run again one minute later and work normally.