Hello hobbit users,
I am looking at changing the graph for load average (if possible).
Actually, this applies to a few of the graphs.
Typically, our systems are very busy during the day yet at night are
mostly idle (load average of around 10 to 12. When you look at the
graphs produced from a capacity planning perspective, for the last 48
hours, you get accurate values, but from a 576 day graph, the load
average is much lower as it is taking into account the out of hours
period.
I was thinking it would be nice to see a line plotted on the same graph
showing the peak value for the sample rather than the average.
I have been reading through rrdtool man pages but every change I make
seems to stop the graphs being produced.
Ideas?
Thanks
Phil
=======================================================
IMPORTANT INFORMATION
This message and any files transmitted with it are confidential and should be read only by those persons to whom it is addressed. If you have received this message in error, please notify us immediately by way of reply. Please also destroy and delete the message from your computer. Any unauthorised form of reproduction of this message is strictly prohibited.
It is the duty of the recipient to virus scan and otherwise test the information provided before loading on to any computer system. No warranty is given or made by Asgard Wealth Solutions Limited, Asgard Capital Management Limited or SECURITOR Financial Group Limited that the information is free of a virus or any other defect or error and they will not be liable for the proper and complete transmission of the information contained in this communication, nor for any delay in its receipt.
Any views expressed in this message are those of the individual sender, except where the sender specifically states they are the views of Asgard Wealth Solutions Limited, Asgard Capital Management Limited or SECURITOR Financial Group Limited, as the case may be.
=======================================================